SSI-103VC-2 (two channels)
Dual Channel / Four output strobe controller with intensity control capability
Model#: SSI-103VC-2
| Electrical Specifications: |
Output Current:
|
8.5 Amps total output per channel |
Output Voltage:
|
Adjustable 8-23.5V (each channel) |
Voltage Control (for intensity adjustment):
|
Two ranges 0-5V and 0-10V (user selectable) |
| Voltage control input impedance: |
20 kohm |
| Maximum input voltage: |
+20V, -10V |
| Voltage control input cutoff frequency: |
7 Hz |
| Pulsewidth: |
Adjustable 10-350 usec (shorter or longer
pulsewidths available, consult Metaphase for details) |
| Pulsewidth Repetition Rate: |
0-60 Hz (external trigger), channels are independant |
| Internal Test PRF: |
30Hz |
| Input Voltage: |
120/240 VAC +/-10%; 50/60 Hz |
| Power Consumption: |
Less than 40 Watts |
| Operating Temp. Range: |
0 to 40 deg. C |
| Storage Temp. Range: |
-20 to 85 deg. C |
| External Trigger: |
TTL Compatible; Rising or Falling Edge, Open Collector
|
| Synchronization Output: |
TTL Positive-going; pulsewidth same as optical pulse |
| Output Protection: |
Resettable fuse for short across output terminals or from either terminal to ground
|
| Front Panel |
Intensity Knob:
|
Ten-turn potentiometer for intensity adjustment
|
Pulsewidth Knob:
|
Ten-turn potentiometer for pulsewidth adjustment |
Rise/Fall Select Switch:
|
Allows triggering on the rising or falling edge of trigger waveforms, one switch per channel. |
| Rise/Fall Select Switch: |
Selects between a free-running ‘TEST’ mode (which pulses the outputs at 30pps) and the ‘RUN’ mode (where the outputs pulse via external triggers) |
| Rear Panel |
Control Voltage Internal/External Switch:
|
Allows the intensity to be controlled from the front panel knob or from a voltage supplied to the I/O
connector on the rear panel.
|
Control Voltage Range Select Switch:
|
Allows the external control voltage range to be set to 0-5V or 0-10V |
I/O Connector:
|
9 Pin D-subminiature used for trigger input, and
synchronous output, and control voltage input. |
| Output Connectors: |
(4) 15 Pin D-subminiature, (2) Outputs per channel,
CHANNEL OUTPUTS ARE SYNCHRONOUS |
| Power Entry Module: |
UL/CSA/VDE rated DPST power switch with double
5x20 mm fuseholder, 0.5A, 250V, SLO-BLO |
| Dimensions: |
L(8”) x W(8”) x H(3”)
|
* Data and specifications are subject to change without notice.
Please contact Metaphase Technologies at
215-639-8699 for more information. |
