Provides independent, constant-current control of two LED loads at up to 4amps continuous DC and a maximum output power of 60 Watts per channel. In Pulse (Strobe) Mode, the ULC-2 is capable of output currents up to 40 amps. The ULC-2 is capable of driving LED forward voltages between 3V and 20V and higher, but with a possible reduction in maximum pulse current. Pulsewidths are adjustable down to 2 microseconds and external trigger rates up to 50kHz.
|Number of Channels||2|
|Voltage Input||24VDC +/-10%|
|Voltage Output||3V to 65V|
|DC Current||20mA min to 4A max|
|Pulse Current||100mA min to 40A max|
|Pulsewidth Minimum||2 microseconds|
|Pulsewidth Maximum||60,000 microseconds|
|Power Output||60 Watts/channel|
|Trigger Input||Opto-isolated, 3V-24V, 7mA draw, rising or falling edge triggered or falling edge triggered|
|Trigger Rate||Up to 50khz|
|Ethernet Control||UDP messaging over 172.16 sub-net – UDP Port 5000|
|Operating Mode||DC, Pulse (Strobe), Constant Voltage|
|Expected Lifetime||75,000 hours|
|Dimensions||7.40″ x 4.72″ x 2.27″|
EASY TO USE CONTROL
User-friendly LCD front panel display with keypad or the ULC-2 can be embedded into custom
applications using the ULC-2 instruction set or the included MetaBoss software
*Please refer to the diagram below for LED output and trigger input connections.
The ULC-2 shall be powered by a user-supplied power supply having the following ratings:
• Switching power supply preferred
• To minimize rise-time distortion and guarantee pulsewidth values, keep all LED load
wires as short as possible.
ULC-2 Trigger Inputs
For external trigger operation, each channel provides separate trigger inputs. Trigger pulses enable the
LED output for a period set by the Pulsewidth parameter.
ULC-2 LED Outputs
With the ULC-2 un-powered, connect channel 1 & 2 LED loads to the positive and negative LED outputs.
IP (Ingress Protection) Rated
Please contact Metaphase or your local representative for information regarding
IP rated versions of this light for harsh environments (water, dust, etc).